UFC 1 -300-08
30 JUNE 2004
property classification plan that can be used for development of the various items on the
DD Form 1354 for this project. Recommend that a draft 1354 should be identified as a
deliverable from the design process and this draft reviewed and approved by the
installation DPW/FacMgr/BCE along with other design documents. The best time to
prepare this draft is during the design phase. Identification of items and their category
codes is more important; estimated costs are less important for the draft 1354.
2-4.13
Block 13. [CATEGORY CODE DESCRIPTION]. Use the service
implementation of DODI 4165.3 (e.g., DA PAM 415-28, NAVFAC P -72, or Air Force
Handbook 32-1084) to determine the correct facility category code short title as the
verbatim description that corresponds to the category code entered in block 12.
2-4.14
Block 14. [TYPE]. Indicate the type of construction: P = Permanent, S = Semi-
permanent, and T = Temporary. For definitions of each type of construction see Draft
DODI 4165.14, DOD Real Property Inventory Reporting and Forecasting, or Service real
property regulations.
NOTE is for Blocks 15 through 18. Each Service category code reference
stipulates an area or a capacity/other unit of measure, or both. If both units of measure are
stipulated in the reference, then both are required on the DD Form 1354. If only one
measure is required, place N/A in the other two columns.
2-4.15
Block 15. [UNIT OF MEASURE-1; AREA]. Enter in this column the
appropriate Unit of Measure for area for each design use category code for each item of
real property, i.e., only SF, SY, or AC. The service implementation of DODI 4165.3 (e.g.,
DA PAM 415-28, NAVFAC P -72, or Air Force Handbook 32-1084) identifies the
appropriate area unit of measure for each real property category code.
2-4.16
Block 16. [TOTAL QUANTITY-UM 1]. Enter the total quantity of area for the
Unit of Measure-1 for each item of real property. For buildings, enter the gross area. For
demolition, enter negative numbers in parenthesis or attach an Authorization for
Demolition.
2-4.17
Block 17. [UNIT OF MEASURE-2; CAPACITY/OTHER]. Enter in this column
the appropriate Unit of Measure for capacity/other for each design use category code for
each item of real property. The service implementation of DODI 4165.3 (e.g., DA PAM
415-28, NAVFAC P -72, or Air Force Handbook 32-1084) identifies the appropriate
capacity/other unit of measure for each real property category code.
2-4.18
Block 18. [TOTAL QUANTITY-UM 2]. Enter the total quantity of capacity/other
for the Unit of Measure-2 for each item of real property. For demolition, enter negative
numbers in parenthesis or attach an Authorization for Demolition.
2-4.19
Block 19. [COST]. One of the primary purposes of the DD Form 1354 is to
identify the cost of individual facilities contained in the construction project. These costs
are required as part of the Service's Financial Statements. The preparer must identify the
2-8
Previous Page
