MIL-HDBK-1003/3
APPENDIX D (Continued)
Electrical Inspection
Incoming Voltages - A-B Phase: ___ B-C Phase: ___ C-A Phase: ___
A-Neutral: _____ B-Neutral: _____ C-Neutral: _____
External Control Voltages (source): __________ Fused: __________
External Process Signals (4-20 mA, 3-15 psi, 0-10 vdc, 0-250
ohm): __________________________________________________________
Process Signal Sources: ________________________________________
.................................................................
Set Up Parameters
Accel Time (sec): __ Decel Time (sec): __ Second Accel/Decel:___
Auto Restart (Y/N): ____ Multiple Attempt Restart (Y/N): _______
Maximum Speed: ____ Minimum Speed: ____ Extended Freq. (Y/N): __
Torque Boost (level): _______ Gain: ______ Offset: _____________
Set Up Notes: __________________________________________________
________________________________________________________________
.................................................................
Operational Parameters
Inverter
Bypass
Line Current
A Phase: __________
A Phase: _________________
B Phase: __________
B Phase: _________________
C Phase: __________
C Phase: _________________
Load Current
A Phase: _________
A Phase: __________________
B Phase: _________
B Phase: __________________
C Phase: _________
C Phase: __________________
DC Bus Voltage: ___ Heat Sink Temperature (1 hr run time): _____
Frequency Output at 0 % Reference Signal: ______________________
Frequency Output at 100% Reference Signal: _____________________
Start Up Complete (Y/N): ___ Completion Date: ___________________
Start Up Completed By: _________________________________________
Remarks: _______________________________________________________
204
Previous Page
