UFC 3-300-10N
May 2005
Including Change 2, August 2006
2-2.12
Cranes.
All crane design and installation must be in accordance with the applicable provisions of
the following:
a. NAVFACINST 11450.1A, Acquisition and Management of Weight
Handling Equipment
b. NAVFAC P-307, Appendix E, Weight Handling Equipment
c. UFC 3-320-07N, Design: Weight Handling Facilities
d. CMAA Specification #70, Specifications for Top Running Bridge and
Gantry Type Multiple Girder Electric Overhead Traveling Cranes
e. CMAA Specification #74, Specifications for Top Running & Under Running
Single Girder Electric Traveling Cranes Utilizing Under Running Trolley
Hoist
f. ANSI MH27.1, Specifications for Patented-Track Underhung Cranes and
Monorail Systems
2-2.12.1
The design of crane or monorail support members and systems must also
be in accordance with UFC 1-200-01, except Paragraph 1607.12.2 of the IBC will be
modified to require the maximum wheel loads of the crane shall be increased by 25
percent for all types of overhead cranes to determine the induced vertical impact or
vibration force.
2-2.13
Fall Protection.
Fall prevention and protection must be considered at a facility whenever there is a need
to perform maintenance work or storing of equipment at heights. At the planning and
design phase of a project, fall hazards should be considered and eliminated whenever
possible. When elimination or prevention of fall hazards is not feasible, the design must
include certified and labeled anchorages meeting the requirements of OSHA and the
American National Standards Institute, ANSI Z359.1. Where fall protection is required
in the vicinity of weight handling equipment, care must be taken to prevent potential
conflicts between the weight handling equipment and the fall protection measures.
2-3
QUALITY ASSURANCE.
2-3.1
General.
Quality Assurance / Quality Control must be in accordance with UFC 1-200-01. This will
include inspection and testing, and may include a Quality Assurance Plan and Structural
Observations where applicable.
10