UFC 3-120-01
FEBRUARY 6 2003
Non-compliant letters and numbers may be applied to the sign face either by the application of die-
cut material or by silk-screening. Die-cut vinyl letters and numbers with adhesive backing that are
individually applied to the sign face are used for one-of-a-kind signs, such as direction signs.
Graphics that are silk screened directly onto the sign face are used for mass-produced signs, such as
regulation signs. If greater durability is required, the graphics may be applied to the reverse side of
clear matte acrylic, back sprayed with enamel and then bonded to a backing panel. Use adhesive
faced vinyl letters or numbers for one-of-a-kind signs. Use reverse silk-screening for mass produced
signs.
12.20. Interior Signs Changeable Graphics.
12.20.1. Directory. The directory section of building directories is a slotted changeable letter
board which accepts molded plastic letters that spell out the names of the tenants. The letters
have tabs that align the letters in the slots of the letter board.
12.20.2. Insert Panel. The insert panel of the floor directories or office identification signs
consists of a clear sleeve that will accept a paper or plastic insert identifying the tenant or
tenants. This insert may be prepared in the following ways.
12.20.2.1. Die-cut vinyl letters applied to .015 rigid vinyl film.
12.20.2.2. Dry transfer letters applied to paper card stock.
12.20.2.3. Typeset message photographically enlarged to size and mounted on paper card
stock.
12.20.2.4. Typewritten message photographically enlarged or used at actual size.
12.20.3. Method. The method most appropriate to each building should be chosen, and the same
method should be used consistently throughout the building.
246
Previous Page
