Table 46 (Continued)
Change oil after 100 hours of operation.
Drain and flush, clean interior, and refill.
Clean, check alignment; check sprocket
teeth; lubricate chain and sprockets.
If used, clean and lubricate according to
Check alignment, tension, and inner cords
of belt drives.
Dipper and float valve
Check dipper clearance and adjust float
Inspect sight feeders, rate of flow, piping,
If cracks occur, special linings should be
Disassemble, clean, and overhaul.
D-Daily; W-Weekly; M-Monthly; SA-Semiannually; A-Annually; V-Variable, as
conditions may indicate.
The frequencies shown are suggested frequencies that may be modified by
local command, as individual installation conditions warrant.